optionrefi.com

Home > Hard Drive > Can't Boot From Sata Hard Drive Anymore

Can't Boot From Sata Hard Drive Anymore

Contents

also under the cmos i did push f5 to load factory defaults and saved them, then reboot and checked them again to make sure everything was right. P4 3.0E, MSI PT8Neo-V (PT800) (Bios V. 2.0 rel. 04-11-05), 1 gig Kingston Value Ram - 2 x KVR333X64C25/512, EVGA 7600GS AGP 256, 2 x Seagate Barracuda 160GB IDE, SB Audgigy, November 30, 2012 James Well, anyway i figuered one of my problems. October 26, 2009 Alex Hi, I think I have a bit of a problem… I have an old Dell Dimension XPS with 2 hard drives. http://optionrefi.com/hard-drive/sata-hard-drive-failure.php

WELL TO ME EVERYTHING THAT CANNOT HAPPEN DOES!!!!! This was done approximately two years ago and, until now, there have been no further problems. I tried different connecters and different sata ports in my MB. You just would lose ability to use the optical drive temporarily, but it would be interesting to know whether that made the SATA drive unit appear in BIOS. http://www.tomsguide.com/answers/id-1850390/bios-boot-hdd.html

Hard Drive Detected In Bios But Won't Boot

should I install a new cable to the mobr also while I got it apart? Any ideas or solutions? With those two systems, they were both from an AMD computer, but different motherboards. And PXE OpROM?

Also had formated it through windows and checked it for errors before. What do I do now? There I found a Windows drive for the Internet connection. Hard Drive Not Showing Up In Boot Priority If you borrow a floppy drive and a floppy data cable from another computer, you can install the SATA drive controller drivers from a prepared floppy disk after pressing F6 near

Main Sections Technology News Reviews Features Product Finder Downloads Drivers Community TechSpot Forums Today's Posts Ask a Question News & Comments Useful Resources Best of the Best Must Reads Trending Now her optical drive is an ide drive.i am going to enable pata and try it like u mentioned. The jumper pins on the back of the drive should be set to Master for the Primary and Slave for the Secondary. Forums > Tech Support > Can't Boot From DVD Drives Anymore "Can't Boot From DVD Drives Anymore" Started 10/21/2008 by Mike MacKenrick in Tech Support Forum (12 posts)

Reply to marikan m 0 l Fred_15 January 18, 2016 9:22:33 PM unksol said:Enable CSM. Bios Detects Hdd But Wont Boot I can see it under device managment but only as a disk drive without any name. That's things like making sure the SATA ports are Enabled, the modes are set to what you need, CPU voltage is set to the correct value for your CPU, RAM voltage You can then move the files off.

Computer Won't Boot With Second Hard Drive

All… Surge Protector, Uninterrupted Power Supply or Power Conditioner 95 Comments sheldon hey guys.sumtimes my computer goes to a blue screen and says theres a critical error and your computer needs unksol said:Enable CSM. Hard Drive Detected In Bios But Won't Boot I still get this error, but now I can enter bios, do nothing, exit bios and it will load Windows perfectly. Pc Won't Boot From Hard Drive For more news about Jack Wallen, visit his website jackwallen.com.

Did you look under disk management (right click Computer, select Manage, then Disk management). this content I have newly acquired an e-machines E3031 (ms-2707 ver.2 mother board) hardly used from new. Once cloned however Bois no longer recognises it but windows does (defraggler, Acronis, disk management and can even directly access content in it). In this screen, most BIOS's will not even let you choose a drive it does not "see". Computer Won't Boot From Hard Drive

Also i already did a Low Level Format to HD, and i also replace MBR just in case… but the problem is not solved. JS1999Jan 15, 2013, 11:51 AM Hello,I had a problem similar to yours where the hard drive in a Dell computer wasn't recognized. Then you put that CD into the machine's optical drive and boot from it. weblink it started booting slow then slower after a window 7 update which was attempting to install IE11 which failed repeatedly.

What would happen if you made Spellskite Hexproof? Bios Can't See Hard Drive BEST SOLUTION EVER!! It is called Data Lifeguard, and this linkhttp://support.wdc.com/product/download.asp?groupid=613&sid=30&lang=enwill get you to where you download a version to put on a CD.

TQ VERY MUCH BY FRED FOO Reply to Fred_15 m 0 l CyrilXp July 27, 2016 8:57:21 AM I had the same problem tried all the options offered but failed eventually

Usually this results in a short freeze after which everything works fine again. I went to work one yesterday and everything was fine, I left my Windows 7 system running as I usually do. The process was successfully completed, and the next time i restarted my laptop, the bio popped up. How To Add Boot Option In Bios Asus Was it running in that computer before?

What is that CSM? OMG! I had an error such as :" reboot and select proper boot device or insert boot media in selected boot device and press a key" I checked bios and had to check over here The recovery disks might or might not work with the new drive.

If this is an extra drive, you can partition and format it using Disk Management in the Admin Tools section of the Control Panel. He’s an avid promoter of open source and the voice of The Android Expert. http://www.newegg.com/Product/Product.aspx?Item=N82E16822148764&nm_mc=TEMC-RMA-Approvel&cm_mmc=TEMC-RMA-Approvel-_-Content-_-text-_- It is not showing up in my Bios or Disk management, only my normal 250gb hdd. lol MxFragz said:Hello everyone !

I have a dell demension 8200 desktop which was seriously infected where I could not do anything with it. Note: The system restore typically can work only if the system restore partition is intact. 3: Get to know BartPE There are tools... any help would greatley be apreciated.I am a newb but have some understanding of it all and I am a very fast learner.but not a great speller. Should I try to Flash the BIOS?

I would highly recommend that at this point, you copy your data over to another drive — just in case. i have two internal HDDs one is WD(two years old) and a new samsung(master).. I have the exact same problem: my HDDs are listed in the Advanced SATA configuration, but not in the Boot option priorities... What should i do?

It may boot if the cofiguration is close but the license will not work Jul 28, 2013 at 8:46 AM #10 CERN MARK II New Member Joined: Jul 28, 2013 can anyone plz help me? what to do???? Aug 3, 2013 at 6:00 PM #24 CERN MARK II New Member Joined: Jul 28, 2013 Messages: 7 (0.01/day) Thanks Received: 0 Yup, I had it as the only drive attached

unksol said:Enable CSM.